72 duster Build progress

still have to grind all the welds down


took a break from metal fab for a bit so I could strip the paint off of the quarter and get a better idea of what I was looking at for smoothing things out....I had planned on stripping all the paint off the car anyhow.

there are a couple bumps and bruises here and there and a couple little dents I found hidden under the paint....nothing to horrible.

I have one small pin hole of rust where the quarter panel meets the rocker that I have to patch and I have one small patch I have to make on the front side of the wheel well where I see a few pin holes of rust....not a very big task so it should take long when I get to that point.





did I mention stripping paint sucks? lol



then I busted out my file board to show any high and low spots in the metal.....I have a few little ripples around my weld but nothing major. a few other dings and low and highspots throughout the panel that I have to smooth out too.



it was getting to late to run my sander so this is where I left off for the night.