Super Six install pics

cudamark said

I noticed the same thing on the hose connections. Also, your triangle washers are on backwards and the hardware for the end studs are incorrect. I don't know about the center stud....I don't see one in any of the photos except the first one....and it was wrong too.

Click to expand...

(over at slantsix.org)

Yes, Coned hardware point away from manifolds. And the grooved nut side goes toward the washer. There is an entire article on slantsix.org on mounting hardware orientation. important for crack resistance http://www.slantsix.org/articles/manifold-install/types-mounting.htm

PCV can go on the rear runner nipple if there is no "below the butterfly" vacuum port on the carb. Trucks have the EGR block off plate, or make one.