Shifter adjustment(Hurst promatic 2)

I just installed the Promatic 2 in my Dart a few months ago.

I believe the lever with the weld is the correct one. As far as adjustment, if I remember right the instructions tell you to ratchet the shifter down into 1st gear position, then get under the car and move the lever on the tranny all the way towards the rear, which should be 1st gear. Then adjust the cable so the pin drops into the hole in the lever.

I adjusted mine by using the two nuts where the cable is mounted to the bracket on the trans. By moving both nuts one direction or the other on the cable housing you can move the whole cable including the pin forward or backward.

I got mine where I thought it was right and it dropped right in, but then it shifted a little weird, wouldn't quite go into nuetral, adjusted the cable again, and it works fine now.

Good luck.