Torsion bar Ancor Crossmember

It wasn't as much that it doesn't work.. it looked like it was cut out with an acetelyne torch. The pieces were not anywhere close to fitting and needed a lot of grinding to clear what needed ckearancing. Finishing of edges? Non-existent. Since the reason I bought it was because the torsion bar socket snapped out of the original, I had to weld it in to the cap, and the hole in the cap was cut out again with a torch.. not even round! or if a plasma cutter, by someone who never had used it, or knows what a "circle" is. It was three flat plates, crudely cut, and more crudely welded together! The edges at the side to bottom were off at least 1/16" at the best spot.

It was a Mickey Mouse looking piece that looked like crap before and after installation. For the same price as one side cap, I had crackedback ship me a full rust-free crossmember from California to Canada. If you're even considering to have to replace both, save yourself the aggravation.

Grant