Single Turbo Blow through Small Block Kits???

CUUDAK said
I can tell you I have nearly $600 in the hotside including the 5" downpipe I purchased from MadDart. Thats just the materials including all the 3" mild steel .067" thickness mandrel bends(two 7 piece kits), 6-3" V-band clamps, 6-3" V-band flange kits, Jegster header kit and header flanges. Plus a minimum of 15 hours in fabbing!

This is mild steel, imagine if I used Stainless! Bet it would have been triple the cost on the materials!

I totally belive it. The header I made for blow through vw daily driver started as a used off the shelf header and I had $300 in that. The down pipe is all stainless with a v band and that was $120 of it, For a short stubby pipe with a 90 in it not cheap at all.