Problems with Jeep DIsc conversion??

Superdart,
I had issues.

I went out and bought all of the hardware specified, even the caliper mounting brackets were from the same year (1995) as the brake parts I picked up. However, grind as I might, I couldn't get a single damn wheel I own fit on the hub.
The problem I had is that the caliper mounting bracket had those ears (which the brake pads slide on) and they interfered with the wheel fitting on the hub of the axle. When I tried to spin the tire, I could hear and feel the wheel hitting those caliper mounting bracket ears. I even put the c-clips and pin back in the center section (to push the axle out as much as possible), but it didn't help. I'm sure I was only off by a little bit, but even if I got it to clear, those tolerances would be mighty tight.
If somebody else has run into this issue, please speak up. I tried both 15" rallye wheels and 15" and 14" stock steelies. Nothing cleared it.
Anybody else have this problem? Or a remedy for it?
Just my young gun two cents.

Mike