TTI & (Stock floor shifter)

I know I've been asking a lot of questions lately about the TTIs and have directions, but sometimes directions are not always 100% true.

I have the stock floor shifter and read where it says the lower bell crank for the kickdown and stud must be shortened 3/4" and re-welded. Along with this as well, the lower shifter plate arm is to be cut and rewelded by 1/4".

Can someone with a stock (non-cable)floor shift confirm this.

I think I've read "all" the forum threads and haven't heard anyone state anything about these mod areas or.....***** or have problems. No sence in cutting stuff up if it's not really required or I'm reading the directions wrong :scratch:

Thanks again :headbang: