408 horse power?

autoxcuda said
Could you run my combo in Dyno 2000 ??

416 cid ...4.00 stroke .030 over 340 block
Comp XE274-S solid with 236/[email protected] .502”/.511” 110 L/C
Edelbrock heads ported, stock valve job
M1 single plane, good port match, all cleaned up
9.8:1 compression measured
750 Demon Silver Claw
TTI 1 5/8 to 1 3/4 step headers port matched then coated

OK, a couple of notes:

1/ Small tube/ Open pipes setting works to about the same as a decent full exhaust in real life.

2 / D2000 doesn't recognise the type of head (small chamber vs open, alloy vs cast etc) so it underestimates a bit.

Headflow figs used are:

.100"--62.8 /44.4
.200"--134.2 /100.0
.300"--196.7 /146.6
.400"--233.6 /182.8
.500"--258.0 /203.6
.550"--267.4 /208.7
.600"--276.0 /213.9
.650"--280.8 /215.6
.700"--285.3 /217.4
.750"--286.7 /220.0