Quarter Fitment Problem

440abody said
The gap in the corner is supposed to be there for water to drain out, from what I can see they fit pretty good. You can use a block of wood and a fairly large hammer to convince the trunk floor extention into place. Then use a set of C-clamp type vise-grips to hold it place while you weld it up.
Just remember that these things were mass producced and were FAR from perfect from the factory. The big picture here is make it fit but don't allter the outer skin, if you do all you've done is create more wor for yourself in the end.

Hope this helps. It was really hard to see what you're seeing from the pictures, but anyway good luck and keep us posted.

440a,
It is hard to see in the pix. The problem is that there is good contact along the inside edge of the seam toward the inside of the car. In the lip where the two layers should lay flat together so they can be plug welded. Instead, the two layers separate as you move away from the loose edges. I do not see how the extension could be stretched far enough forward to have a good enough contact to plug weld it. Did I correctly understand what you are trying to say? Thanks.

Jim