**Twin Turbo 67 Dart Project**

Installed the Sensor in the Dizzy today. Came out very nice and it should work well. I am still waiting for the New Reluctor to get here so I can install it.
You can see in the picture that I will be putting the dizzy shaft in a Lathe and taking about 1/4" of material off so the new reluctor will slide down a bit further, it is probably not necessary but I want to try and keep the sensor right in the center of the Reluctor. As you can see I used 2 washers in the inside of the distributor. I ended up cutting about 1/4" off the bottom of the first washer to use as a spacer because of the offset you see inside the dizzy. I did have to trim the Distributor cap a bit but no big deal. Going to order a few HEI Caps for the real deal and I will pre notch both of them so they are ready to go.


View attachment phpM4iXTPPM.jpg

View attachment phpOM5YBePM.jpg

View attachment phpK4qYDHPM.jpg

View attachment phpFarmAbPM.jpg

View attachment phpPqF2T7PM.jpg