Rotisserie Pictures

I built this one almost 15 years ago. I just took two 6x6's and placed them into the ground after the car was in place. I took a couple of measurements and then drilled a hole in each 6x6. I placed some pipe in the hole and attached it to a steel plate. In the back I attached the steel plate to an I-beam, and it got attached where the bumper brackets mount to the car. The front plate was C-shaped and was mounted where the bumper brackets mount. Most was done with scrap pieces and the cost was under $100. The most time was spent trying to figure out where to drill the holes in the 6x6's so it would spin easily. I still have all of my metal plates. If I were to ever need one again I would use those plates, but use steel tubing in place of the wood posts.

Good luck,
Craig