Rebirth of Dustbull-with 408ci, efi, t56, dana 60
Thanks Dusted72, It feels like its taking longer than expected, but were only a bit behind where i wanted to be in the timeline.
Well, Its been a long day without much to show, but progress was made. I welded up the roll bar, I tacked it, then pushed it forward so i could weld the uprights all the way around more easily-that was a mistake. The cage had warped slightly from where i wanted it from the heat, i just had to use a bit of force to tack the tubes to the floor. I was working on the door bar and the 6"x6" floor mount but gave up early tonight.
6x6 trunk mounts
pulled cage down after tacking to finish all the way around
Finally in place where it needs to be
Mounts in the trunk are a bit further back, i thought it would help strenght-wise
More tomorrow, My dad and i are hoping to get the major welding done so we can put it on the lift to remove the suspension before i go (to start prepping for paint).
Thanks Dusted72, It feels like its taking longer than expected, but were only a bit behind where i wanted to be in the timeline.
Well, Its been a long day without much to show, but progress was made. I welded up the roll bar, I tacked it, then pushed it forward so i could weld the uprights all the way around more easily-that was a mistake. The cage had warped slightly from where i wanted it from the heat, i just had to use a bit of force to tack the tubes to the floor. I was working on the door bar and the 6"x6" floor mount but gave up early tonight.
6x6 trunk mounts
pulled cage down after tacking to finish all the way around
Finally in place where it needs to be
Mounts in the trunk are a bit further back, i thought it would help strenght-wise
More tomorrow, My dad and i are hoping to get the major welding done so we can put it on the lift to remove the suspension before i go (to start prepping for paint).