Did you mount the Quicksilver in the stock console? Do you have any pictures if so? My whole purpose of trying to get one of these to work is I don't want to loose the stock console.
Yes I did. Sorry, I didn't take any pics when I was doing it but I have a completed pic I'll attach. I made one big mistake when I was doing it and that is cutting out the original shifter surround in the console. When I was measuring things I measured the total throw of the shifter and it was more than the opening in the stock console by about 1/2". I first tried notching the top plate 1/4" at each end so it would allow full throw of the shifter but didn't like the way it looked. Had that hacked up look even though my cuts were straight. So the only solution I could think of was to cut out the shifter surround and make a top plate cause the top plate that came with the Quicksilver was too wide to fit the console. My mistake was in forgetting the quicksilver is set up for a trans. requiring 4 forward detents so in reality it didn't need to travel the full length to grab all the gears of the 3 speed TF. After I got it installed I realized the factory cutout would have been big enough, UGH! One of these days I'll find a new console top plate and install it so it looks more original. Here's a pic of it and that weird looking thing you see laying just left of the tach is a dead wasp, LOL... I took the pic under low light and didn't even notice it there until I loaded it on the puter.