I'm in the process of adding the top cross members and adding the horizontal light setup. I'll have 4 lights per side ,2 in the front , haven't figured out the rear or top yet. here's some pic's so far.
had to make up a little jig so I could put a straight cut in a round tube. you would not believe how bad it was without some stability in pushing it through the cut. View attachment spray booth setup 001.jpg
ahh straight cut WHEW (the lights slide into the cut and I'll screw them into the pvc sides) View attachment spray booth setup 002.jpg
pic of the light placed in the frames to check for fit. hmm I'll have to cut about 1/2 in out of the short riser between the lights to make it tighter, luckily nothings glued . View attachment spray booth setup 004.jpg
here is a couple of views of the corners and top support braces. I'm waiting on the special 4way corners to come in that I ordered. View attachment spray booth setup 005.jpg
here you can see the difference from the t I had to use to mock it up and the special 4 way View attachment spray booth setup 006.jpg
heres the driver side room and the other pic is the passengers side room View attachment spray booth setup 007.jpg
all told about a 21x13ftx8 room. it won't fit the challenger or my truck easily, but I can fix that by adding a 4ft center panel in the side when I do get around to the challenger. View attachment spray booth setup 008.jpg
I'm getting there