6pakattack Time

6pakattack said

Well,got the chance to see one of my pistons set up in the cylinder today !!!Everyone wonders how far down in the hole it sets !!! Guess what,it doesn't !!!:blob: It's actually about .0200 above deck,with a 59.4cc head !!So depending where Franks head is, I may just be looking at a Non Pump Gas motor !!!:D Oh Darn !!!:toothy7::toothy7:

Click to expand...

Our pistons are .167" down in the hole. Our head and block have the original, factory-machined surfaces on them (neither has been milled, ever) and our combustion chambers have not been modified.

Our compression ratio (measured) is 9:1.

Yours is anybody's guess, at this point (who knows what Frank did?) but it's probably gonna be righteously high, I would think.

That's good news for a normally-aspirated motor!

Let us know what your final calculations are; gonna be interesting!! :)