6.1 Swap Won't Rev Past 3K HELLLLPPPPP!!!

Ok so here is an update. Dad took the car to a CMR dealer today who is VERY familiar with tuning the hemi motors. We have used him in the past for tuning and he knows these ecm's. He spent about three hours working with the software. He updated the diablosport to the lastest version to start with. Next, he disabled the downstream oxygen sensors. He then tried everything known to man to remove the "rev limiter" with no success. He then informed my dad that the ecm which was purchased from S&P as a plug and play part was not what we were told it was. The mapping on it was for a 5.7 hemi and not a 6.1 as we were told. We were told that it was setup for a 6.1. Here we go again!!!! Not only has my dad been ripped off by Ben at Plum Floored, now S&P!! Dad attempted to contact the guys at S&P this afternoon but the tech guys had already left for the day lol. Surprise! As far as the clutch input goes, I wish I had a wiring diagram for this harness. We are almost ready to rip this bullshit out and put a carb on it. How can these guys get away with this ****!