73' B3 340 Duster pro touring build

Okay enough screwing around with duct tape, time to get serious..... I didn't want a flat hood scoop opening( 1st pic) and was looking for something with a stamped look (kind of 3D). I decided a stamping die would be the fastest and easiest route (2nd pic), it 's made from 1/4" 4130 and was used with a 75 ton press to get the desired look. I think it turned out pretty nice (3rd pic) but I had to cold work it to get it right, but once it was installed I think it turned out pretty nice...I definatley will have a one of a kind hood once its all said and done. Its not done yet, but I just have to make the side pieces, weld them in and finish up the bottom side(another 20-30 hours). The air intake is 12" X 2".