Ideal MIG welder set up for body work... What to use? What works best? HELP!

wjaholic said

THANKS!

Oh yeah, inside of the door and all over the manual it sceams at you to change the polarity.


I am going to swtich over to solid wire, I am running a liner for .030 & .035 wire, same with the tips. When I swtich over to the smaller wire I will have to get a new (smaller) liner and a fist full of tips. Very Cool!


Thanks again!

Click to expand...

You do not need to change the liner to run a smaller wire. You will need to pick up the correct size tips for the wire you are running (p/n 087 299 for .023/.025 wire) .Your weld current is transfered to the wire at the tip so it is important to have the correct size. Using a larger hole will give you a wandering arc and less than satisfactory welds. You will also have to install the correct size drive rolls. Your welder should have came with the .030/.035 drive roll kit. you can attempt to use this to feed the smaller wire but it will probably not feed smoothly. More than likely you will need the 087 131 drive roll kit for .023/.025 wire. se the guide on the welder to set you base settings for what you are welding and fine tune from there. ou will get some nice recults with the Miller.