Torsion Bar Crossmember Anchor CARNAGE-Where to get new one?

waggin said
i don't have these removed from the car's yet but can put a rush on it since your in need,let me know and i'll git movin....wagg's

PM sent

crackedback said
half of that crossmember on the pass side isn't even supported. The entire section that should be spot welded to the floor looks to have no attachment.

Take up waggs and get a fresh factory one and don't bother with the spot patch junk. Fix the floor while you are in there to get the attachment points back and supported.

I will be replacing the whole thing, and reinforcing the replacement, as well as sub-frame connectors,etc.

I have taken the interior out and the floor has patch panels in at front and is solid front to back.
The crossmember looks like is was welded in place to floor pan or attempted to be (but probably not as well as it should have been). The drivers side is showing weakening on bottom section, so I imagine this was the state of the passenger side before it fatigued and gave out.

Thanks to everyone for their help so far..........these forums and the members are 2nd to none!