Torsion Bar Crossmember Anchor CARNAGE-Where to get new one?

Thank's fish, I think that adding the plates to the torsion bar tubes should be commonplace for any performance application as well as daily drivers even when the metal is good, if he's ready to git his car ready to ride for the summer I will put a rush on it,if he's in no hurry I can slow down some...it's been hectic the last two weeks........Wagg's

FISHBREATH said

I would take up Waggs on the replacement crossmember. Your existing one is not salvageable. My guess is that the other side is not far behind that one. I would then fortify the replacement. Don't forget to use a lot of welds when replacing the crossmember, many more than the few spotwelds that the factory used.

Click to expand...