front end sits too low

I'm a little out of it at the moment, I woke up feeling rough, so bare with me on this.

The torsion bar sockets in the crossmember haven't moved any, infact I welded them in solid to prevent them from turning/twisting because the factory welds looked horrible :D It does seem like the bars are unwinding, or maybe losing their strength.

I also plan on welding in some reinforcement plates that span the length of the crossmember/frame when I install the subframe connectors.

It's always been used torsion bars, just ones that I had as spares for my cars or for future projects. I've thought about getting a set of new .920 or larger bars, but was skeptical about spending the money, if it turned out to make no difference.