All the Hanger18 mods are done except drilling the pvrc's. I want a baseline before any drilling happens. The carb is sealed up tight. For some reason my carb will not idle. Torn it down 3 times and found nothing. I just slapped my Dads carb on and closed the idle circuits a bit. Still needs to be tuned. I think I am gonna run the vacuum advance to the manifold so it runs better. Initial timing is at 12* atdc so off throttle is a little shakey. By the time its in boost the vacuum advance will be shut down and the mechanical will be in. Then the BTM will pull 2* per pound.