torker 340 intake?

While I think $60 is a decent price, the intake is best used as "On the Cheap" intake. I would not use it with a small cam, converter or low gear set. The intake can and does do fine for being a old unit. However, once the RPM came out, it was done.

Should you build the engine with the TrokerII, build a stout mill. The intake makes a minor come back over the RPM in power some where after 3500 RPM's. SO, if your OK with ignoring torque output below 3500, then have at it.

Port match it and add a 1 inch spacer to it at most. It is capable to run in the 11's and still use pump gas.