'05 9.25 rear rebuildable?

As promised... however forgot my camera when I went to the u-pull-it.

Here are pics of the 9.25 ring, pinion and track-loc rotating assembly

The yoke is the large 7290 (29 spline) which I confirmed is interchangeable with the smaller 7260 from a 489 8.75 (29 spline)

The ring and pinion are 3.55 gears. The oil was super clean and the bearing are smooth and looked perfect. Before removing the axles I tried spinning the wheels seprately but couldn't, I know that doesnt mean thier good but sure does mean thier not shot! lol
Once out I did make sure the retention clips for the clutches were there and in tact.

So I took everything home for under $50

So here you can see where the clutch packs are on these one piece units.