Project- Bills Buggy
Well... I didnt sleep much.. My mood hasnt improved much (go figure LOL) .. I am gonna be leaving for the garage soon and will figure something out.. whether I just seal around the rubber for now, or decide to pull the glass (which I still at this point dont see me doing)... I have a question though.. I asked this a while back with no real response, but for all those that have done Dart resto's before, HOW did you get the back glass in?? In our case after fighting for hours, we had to get a 'rope' (for lack of a better word)all slicked up, that fit inside the rubbers outer groove (the part that fits over the pinch weld).. we put the glass into the rubber.. then laid it on the car while two people were in the car and two outside the car... the two inside started pulling on the rope to 'suck' the seal in and onto the pinch weld.. this was insanely difficult, and had to try several times, finally getting it in.. I dont know what else we could've done.. Now I know there are a ton of people that have done Darts... so pleas.. info requested .. thanks gang