66 dart convertible

I'm getting excited now that I'm moving forward and almost ready to drop her down on her new 4 1/2 inch bolt pattern wheels. so I decided to do a litle work on the engine bay and put some color on it and finish up the suspension. I replacing all the stuff (still need to get bumpers and strut rod bushings) new bearings and seals front and rear. and the leaf's are supposed to be in this week.
here's a shot of the bay, and areas that I'm working on to get ready for the sub frame connectors and seat mounting locations.
here is the seat location tabs. I'm going underneath and welding in support plates and drilling thru to bolt it in better aslo.
View attachment DSCF2893.jpg

here's the back seat mount and the big volt holes in the back are seat belt mounts and the top of the seat hold down
View attachment DSCF2894.jpg

this is the seat back mount and I'll have to weld in some more bracing to the side for seat belt support
View attachment DSCF2895.jpg

new off set bushings installed passenger side wiaitng on the socket to install the balljoints
View attachment DSCF2896.jpg

mmmmmmm nice!
View attachment DSCF2897.jpg

drivers side bushings in and ready to go!
View attachment DSCF2898.jpg

I was suprised that it came out so nice
View attachment DSCF2899.jpg

It looks like I'll be jamming the car for color this week. and adding the brake and fuel lines. so I can get it setup for the subframe connectors with the suspension on.