Slant six to 360 engine swap list?

your 77 360 does not have sensors, only water temp and oil pressure senders. trans mount is the same. you will need the pre 73 biscuit style rubber mount.
just to re-cap for you

360 car engine mount brackets and pre 73 rubber mounts
pre 73 rubber trans mount
you will need to take 4" out of your /6 driveshaft for the 727 + the yoke
small block car manifolds or headers
360 car oil pan/pickup
V8 radiator/fan shroud and trans lines
compatable distributor for your ignition system
shifter linkage
you may need a shorter fan spacer depending on whats on your 360
compatable oil pressure sender for gauge or dummy light
i am using my /6 throttle cable but the V8 cables are around, they are shorter.
make sure you have the correct alternator for your wiring (single wire or 2 wire)

i got my radiator/shroud out of an 86 diplomat

should you decide to switch to an 8 1/4 or 8 3/4 down the road, you will need to shorten the driveshaft even more or locate the correct one.

if you plan on adding long tube headers, now is the time to do it

i may have extended my water temp sender wire, i dont recall now.

all my other wiring plugged right in.

i dont know if truck/van 360 kickdown will work, i think it is the same for the passenger cars if i recall.