You just need to adjust the hood a little bit. It does slide on the bolts back and forth and up and down. Try this... loosen the front bolt of the 2 and have someone tilt the front of the hood down a little to move the position of the bolt in the slot. Then tighten the bolt and close the hood gently and check the clearance. If it still sticks up open the hood back up and loosen just the back bolt. Now lift the hood a little to move that bolt, tighten and check it again.
How is the side margins of the hood?? How bout the front to back alignment?? These are both also adjusted by the hinge bolts. Remember to work in small increments and close the hood gently each time in case the margins are off!! Check back in and good luck!! Geof
