20s for the Demon - how low can I go? (big wheel haters don't look)

blown71duster said
They sell notch kits, This place sells a kit, also check out their frame curves that could also be used.

http://www.welderseries.com/blog/online-store/step-notch-kit-universal/

Thanks. Found that with a google search right after posting. :D
I think I could make this work with some plates welded onto each side:
http://www.welderseries.com/blog/online-store/c-notch-fill-piece-rear/

I bolted my wheel to my axle housing with a tire on it and set the car down onto the tires. The tubs stopped the frame right before it hit the factory bump stop. I then rasied the car 3" and thats where I ended up. 285/40/20 in the pictures I posted. a 325 is WAY to wide and almost 6" wider then a stock tire.

Cool. Looks lower because of the Dart 1/4 covering more. What do you have for springs? There's guys on here going wider than 325. It could work without much trouble.

I have to see what works up front without a spendy solution before I finalize a plan for the back, but I'm thinking seriously of doing the C notch. I'll look at your thread again to see how you managed the front end.