Rebirth of Dustbull-with 408ci, efi, t56, dana 60
I got a lot done that doesnt transfer well to the computer. The ebay TB had the TPS mount holed drilled incorrectly and the bolt pattern is too wide to adapt to my existing elbow, so I ended up making a 1/4" spacer and going with the old nissan throttle body for now. Im going to try and get it started this way, then redesign the elbow for the ebay TB.
I got everything hooked up and turned the key-no fuel leaks BUT when i crank the engine over im not getting a signal from the distributor. Everythings wired and configured correctly, im starting to think its the dist. module that went bad...
Close up of injector tie-downs, tacked into place to get angles all correct:
Please excuse the ugly throttle body, it cant even fit a filter on it its so long w/ the huge radiator hose that i am not a fan of either...
I got a lot done that doesnt transfer well to the computer. The ebay TB had the TPS mount holed drilled incorrectly and the bolt pattern is too wide to adapt to my existing elbow, so I ended up making a 1/4" spacer and going with the old nissan throttle body for now. Im going to try and get it started this way, then redesign the elbow for the ebay TB.
I got everything hooked up and turned the key-no fuel leaks BUT when i crank the engine over im not getting a signal from the distributor. Everythings wired and configured correctly, im starting to think its the dist. module that went bad...
Close up of injector tie-downs, tacked into place to get angles all correct:
Please excuse the ugly throttle body, it cant even fit a filter on it its so long w/ the huge radiator hose that i am not a fan of either...