66 dart convertible

I have been waiting on my pearl powder to show up so I can finish up the clearcoat and start putting the car together sooooo.... I decide to check out my trim and see where/what I have to do. I only have 1 mistake that I'm worried about but it's just visual thing. when I was working on the fenders I must have forced the bracing in a little too far. so I have a distinct angle onthe trim going to the front spear. it lines up with the door perfectly and matches the fender but it starts out wide and goes narrow in reference to the fender. it's not a big thing but it is visible to me. I'll look for another fender so I can correct it since I'm not going to go backwards on this fender. (it was to had to get it even this close)
there is the offending trim
View attachment DSCF3042.jpg
and there is the gap wide by the door and correct on the tip of the fender.

I'm living with it for now.
View attachment DSCF3035.jpg

the passengers side it dead on no screw ups there.
View attachment DSCF3046.jpg

man I'm going to have to work my fingers to the bone making that trim look good, it UGLY.
View attachment DSCF3043.jpg

View attachment DSCF3044.jpg

View attachment DSCF3045.jpg

View attachment DSCF3047.jpg