Doc's 76 Four Door Valiant

Here's an email exchange with Bill Reilly asking for his input about the frame damage:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
From: Bill Reilly [mailto:[email protected]]
Sent: Friday, August 03, 2012 5:11 PM
To: Jeff Sendelbach
Subject: Re: K member question

Interesting kink you have there. Well, the k frame holes on an Abody are symmetrical, so if its a perfect rectangle you're gin. It is also a flat plane, don't forget to check for that.

Bill Reilly
Reilly MotorSports, Inc.

Sent from Verizon Wireless 4GLTE smartphone
----- Reply message -----
From: "Jeff Sendelbach" <[email protected]>
To: "[email protected]" <[email protected]>
Subject: K member question
Date: Fri, Aug 3, 2012 5:15 pm

Hello Bill,
I am working on a 1976 Plymouth Valiant and plan to purchase/use your Alterkation setups front and rear. I just had the body media blasted and primered on a rotisserie, and now I find that there is some slight damage to the frame up front and am concerned that I may have problems with bolting up the new K member kit. I still have the original K member, but am not sure if it is bent/damaged in a way that is not obvious/visible to me.

This weekend I will take measurements of the four bolt holes under the frame that the K member bolts to and see if they are equally spaced or not. Short of that, I was wondering if you have any advice for me?

Thanks!