Looks great. Been wanting to add a console to my ride. What did you make it out of? Did you block the back so that the heat will flow around it? ANd last, how did you mount it to the floor?
It is made out of 1/2 inch thick MDF board, which was then carpet covered, and then installed in 2 pieces. The heater in that car never gets used (heater control valve is rusted shut :(). If I fix that, I will fabricate a heater air flow channel to push the hot air out wither side - Probably some 1 or 2 inch convoluted (thing dryer veny) tube, and then little custom grills on the side.
The console was custom formed to the floor, so is a very tight fit - no mounting done at all. Pretty much just wedged in between the AC vents and the trans tunnel.
@ Hemitheus - I am leaving it as is for now, as in order to wire for the amps, I need to be able to get it out again, then once all that is finalized, I will go ahead and paint those screw heads black.