Project Riddler's Ride - 1976 Plymouth Duster
Well I'm super happy to annouce the floor is completly solid once again. I'd got to get some more seam seal and then lay that down and some POR15 inside and under the car the new tunnel is done.
This was a much bigger job than I expected and much larger than the mini-tub anyday!
Here's the final pics.
You can see small holes here from rust. I cut that out and replaced it.
Banged all the metal flat again the new floor, welded it and then used clamping plyers to hold the seams together while I welded them shut.
Here's the hole I made and replaced with new metal. This was super thin and I couldn't get the welder low enough to weld the holes shut without making more holes.
The final look before seam seal, POR15 and then sound deadener.
So the next things I'm going to work on are:
Shorten Steering Column
Fit hydroboost
Make base for the drive by wire gas pedal
Extend the fuel filler neck.
Riddler
Well I'm super happy to annouce the floor is completly solid once again. I'd got to get some more seam seal and then lay that down and some POR15 inside and under the car the new tunnel is done.
This was a much bigger job than I expected and much larger than the mini-tub anyday!
Here's the final pics.
You can see small holes here from rust. I cut that out and replaced it.
Banged all the metal flat again the new floor, welded it and then used clamping plyers to hold the seams together while I welded them shut.
Here's the hole I made and replaced with new metal. This was super thin and I couldn't get the welder low enough to weld the holes shut without making more holes.
The final look before seam seal, POR15 and then sound deadener.
So the next things I'm going to work on are:
Shorten Steering Column
Fit hydroboost
Make base for the drive by wire gas pedal
Extend the fuel filler neck.
Riddler