Torque Converter Snout Cracked

The body lift is made of 3"x3" square tube that is 1/8" thick. The pieces bolted to the body are 3' long and the one that goes side to side is 4' long. The lift is bolted to the bumper mounts on the front frame rails with the bumper mount bolts. To remove the eng/trans I did the following:

1) Remove torsion bars.
2) Disconnect lower ball joints.
3) Disconnect outter tie rod ends.
4) Drain trans fluid and remove exhaust and drive shaft.
5) Take out steering column.
6) Drain coolant and remove radiator and alternator, disconnect coolant hoses.
7) Disconnect all wires and speedo cable.
8) Lower car so drive train sits on dollies.
9) Remove k-frame and trans cross member bolts.
10) Raise car body up.
11) Push drive train out from under the car.

The wood sitting on the dollies are two 2"x10"s.