Doing Bodywork on my own car need some assistance. Please

AdamR said
DA the old paint with 180. Do your body work over 80 grit. You can shape the filler with 8o then finish it with one 80. You can also do your filler over epoxy.

The epoxy usually needs to be topped with 2K with in 72hrs, The tech sheet will tell you how long you have. After that you have to scuff it to top coat it.

For the 2K I do my blocking with 180, usually 2 rounds to make sure its straight. So 180, then re-prime. Then I go 180 again but leave enough material to go over it with 220 if I can. If not re-prime and block with 220. Primer should fill the 220 scratches.

Then re-prime and wet sand with 400, then 600. Remember to use a guide coat each time to sand.

Ok Adam I have been thinking about this since you posted it. The step that I am confused over is "do your body work over 80 grit." So after I DA with 180, I spray with epoxy then do the filler over the epoxy and shape it with 80. Then I go over the filler with 180. After that is done I spray the car with 2k and this is when I start to block the car just like you stated for what you do with your 2k, blocking it with 180 for 2 rounds correct?