got it started today hooray

Since your computer isn't throwing any TPS codes you may simply need to calibrate your throttle. I don't know if it will solve your problem but since it will literally take less than a minute and involves no tools I don't think it can hurt.



Here are the procedures I've found on a couple of other forums.

Procedure: To overcome hesitation at acceleration for the Hemi V-8 only:

1) Turn key to ON position (not ACC), but DO NOT start engine.... now wait a few seconds for the dash lights to clear

2) slowly & steadily press accelerator pedal all the way to the floor and then slowly release at same rate.
NOTE: This step must be done ONE TIME only to ensure accelerator pedal position sensor calibration has been
learned by the ECM

3) Leave ignition switch ON for a minimum of 10 seconds. This will allow the PCM to learn the new electrical parameters

Info re: APPS - The Accelerator Pedal Position Sensor (APPS) is used only Hemi V-8 engines. The APPS assembly is located under the vehicle battery tray. A cable connects the assembly to the accelerator pedal. A plastic cover with a movable door is used to cover the assembly.

Hope this helps.

Regards,

Joe Dokes