904 extention housing bushing

I bolted a couple large sockets together to drive the bushing in and out. To drive out I used a socket that just fit inside the bushing and one that was slightly smaller than the bushing ID. Then to drive in, a larger socket was used such that it served as a stop when the bushing was fully inserted. I drove only from the tail. It is often best to always work the same direction if possible, other wise the metal become rough making it difficult to drive in. It is important to allign the oil hole.

I placed the large end of tail on a board, and used a large dowel rod and hammer to drive the sockets. I tested with oiled drive shaft yoke prior to assembly, all was well.