Cam selection help

"that would explain it right there, another thing people need to know is starting out as 1.88 heads there is way more work than one would think to get them just to 230cfm just cutting to 2.02."

x2 - as the rest of the posts say...
Normally when I replace the valves I bring the seats up and out - so I go with 2.02 if they are 1.88s, or 2.05s if they were 2.02s. I will also:
- Do a 5 angle valve job - this provides the main bowl hogging and also unshrouds the chamber
- Rework the bowl with minor attention to the guide boss - I don't eliminate it - just reshape a little.
- Round and lay back the SSR slightly.
- Gasket match the opening and blend in past the pinch, enlarging the pinch area. I do not touch the floor
- I do not polish - in some spots it's left at the carbide burr finish others I'll hit with a coarse sand roll.