71 Duster 360 (new project)

Currently the plan is to use a 4.30 gear unless a 4.56 fall out of the sky...and converter is a 10 inch that is suppose to flash to 4200...

I have a set of 9 x 29.5 ....but would rather run 9 x 28 with the 4.30 gear...

also do not want to get into mini tubbing or moving spring in at this time...should be starting on the rear end next late next week..

side note...dont know the kid who owned this car.....but...both bolts that hold the trans to the cross member were gone..i see 2 of the 4 bolts on the master cylinder...plus the manual brake pushrod will fall out if you lift up on the brake pedal...missing like rubber thing,,,,the front tires look new until you look at the inside thread...down to cord due to the worn out front end...