Riddler said

I found some time today to get some work done. My goal was to button up the floor. I gave it my best but I failed. I did have a good start and wish some cardboard I can make templates and finally finish the floor.

Here's the bridge over the trans I made. It's 2"x1" C channel and has 1/8" plates to weld to the sheet metal floor.




I've finished welding it up but never got a picture. I also clearenced a few sections so that I've 1/4" or more of space from the trans to the bridge.

I then moved on to messing with the pedals and hydroboost. I took all the brackets off the pedals I didn't need. Anyone looking for heavy duty 340 brackets etc?


Here's what I was left with.



I then mounted up the hydroboost. The brackets were perfectly to the firewall. Just have to take a hammer and smack a buldge down about 1/4". I then however stuck a hemi head on the driver's side and found that the hydroboost won't allow for the room needed to mount the valve covers.


I'm going to run to the laser cutters this week or early next week and see about getting another brackets cut for clock the hydroboost counter clockwise 90*. This will allow me the extra space I want to have to install and remove the valve covers. I'm also going to have to have a bracket made to clock the master back 90* in the other direction so it mounts flush.

Riddler

Click to expand...