Project 6-71 340 Demon

WoW, it was a close call. I set the intake and blower on the engine today. The bad news was I am going to have to have the head mating surface of the intake planed down. I didn't know the heads had been planed in the past. The only way I could get the bolt holes to line up was to take the gaskets out and then it was tight.

On to the intake and blower fitment. It looks like the only thing I will have to do is take 3/8 of an inch off of the very rear of the blower mounting plate. There is lots of meat there as it overhangs the rest of the intake by quite a bit. The blower did not interfere at all after I took the decorative MSD plate off the top of the dizzy. It's tight but should work no problem.

Looks like I dodged a bullet on this one.

Jack