Cuda SRT8 392 Gen.III Hemi

JD, the big square hole for the harness connector was no longer needed because of the ISIS system I have. Unless something else comes up, my only wiring penetrations throught the firewall will be the ECM connector/harness and a 10quage wire from the ISIS micro processor to the front power module. I'll probably use an aftermarket gas pedal, but it will still use the same gas pedal holes and use a cable, as my throttle body is cable driven rather than drive-by-wire. Thanks much for the compliments. (I'm not use to all the compliments except from just a couple of close friends who have seen the car.)

JDMopar said

I would also be interested in what type wiper motor you will be using. I also noticed that you filled in the square hole that held the original wiring harness. What about the hole for the factory gas pedal? Will you use that for something else? Very nice work! :prayer:

Click to expand...