Pulling Slant 6 Without Removing Transmission

805moparkid said
remove the fan and radiator. crane up the motor a little, then remove the mounts from the engine block. lower the engine and pull forward...

All done already.

ESP47 said
Did you remove the 4 bolts attaching the flex plate to the bell housing?

Manual transmission

805moparkid said
i thought it was a stick?

you thought right :)

winstoninwisc said
can of squirrel piss shift linkage starter exhaust manifold electronics

got a bolt in yet? they got a tie brace

All that is pulled

pishta said
I would pull it all, use the rear threaded boss on the head and hoist the whole thing out. You may have to pry the trans back off the pilot bearing as it is sitting cocked now.

Head is off already... i think I , may have the engine tilting back and its putting pressure one the tranny. Should I be able to pry the engine forward off the pilot bushing?