Barn find 72 340 duster

Was having the most difficult time getting the trunk floor to fit in the pass. corner. I keep messing with it and was cussing the repo trunk floor pan when I stopped to investigate further and found what is was that was causing the problem. You can see in the photo that the spot welded trunk floor was off at the factory and of course the pan was welded in anyhow. Might be hard to tell but the corner is off about a 1/4 of an inch. the area that is highlighted in white paint should be even so would would not be able to put any paint there. So all the cussing AMD got this afternoon about ill fitting sheet metal was undeserved. I did get most of the replacement sheet metal mocked-up and am very happy with the fit. Ran out of daylight and time before I could get the trunk drops into place but could not be happier with the fit.