SRT8CUDA Build

The rear suspension is the RMS Street Lynx 4 link and the axle is a Moser 8-3/4" design. The axles are a custom 33 spline and are modified for Ford (ugh) tapered roller bearings to accommodate the rear disk brakes.
When we first installed the rear axle it was too far back in the body. A check with Bill at RMS revealed that he had mistakenly packed an unmodified lower strut bar. Bill explained that these are made in one length and then cut to fit different body styles. He immediately volunteered to send me the correct ones or explained that I could cut off 1.75" and thread the bar deeper. I decided it was easier to modify the bars myself.
The length of the bars is then set to 20.5" for the A Body. The upper bars are set to 10.5" long.
The axle was then correctly centered in the wheel opening.