Dougs clearance pictures

I am uploading some pictures of the drivers side dougs headers with power steering. I did as shown in the pictures measured the dimensions from the kframe to the crank center and then the offset from the kframe bolt holes to the center which shows a 2.5" offset. Seems the dimensions look fine, but I am still touching the power steering pump? Any helpful observations? I might have the tip of the engine relative to the tranny mount too low which may give me the clearance when it gets bolted in the car, but I did mess with that a little and saw no real change? I have about 1/4" of clearance on the center two tubes which I think is fine. It is the first number 1 tube that seems to be brushing against the steering box on the side where the box has a very slight arc shaped contour. I was hoping to get the same 1/4" there as well. I think by my measurements the engine is sitting in the center. Looking at this with my mind, I want to say the engine should move that 3/16" to a 1/4" to the right or drivers side, but I cannot get it to go there? I did disconnect the torque strap but that did not help either?