Slant won't start!!?!!?!?

Good news! It started! I decided to try a new head so I hit the yards and found a candidate. I cleaned it up and lapped the valves which resulted in the following:

Cyl
1) 90psi
2) 120psi
3) 90psi
4) 120psi
5) 120psi
6) 105psi

So I think the head cracked or warped but the head cost me less than any machine work so it turned out ok. It's running a little rough though at:
10 degrees
700 rpm
13-15 in/Hg needle vibrates from 13-15

I had the valve cover off and the pcv valve hose is tearing.
Also, I'm leaking a lot of fuel from the charcoal canister/fuel pump area.