Using mustang rotors for 4.5" bc

I had a few problems I had to iron out to get them to work.

I had the problem with the rotor rubbing the dust shield like some other people did. I just took them off.

Next issue was the outer bearing would bottom out on the spindle with the rotor installed, leaving a small amount of play. I chamfered the bearing a little to get it to tighten into the rotor race.

The castle nut was to far in for the cotter pin to go through it. So I added another washer to move the nut out to where the cotter pin can engage the castle nut.

I have $96.00 in two rotors with free Amazon shipping.

I paid $50.00 for the machining cost. I took 3 weeks though.

I bought two inner and two outer bearings, two Mopar seals, and two spindle washers.
I have under $200.00 in it.