1965 Dodge Dart Charger

Today I got hold of two gas caps!

The first one is painted by the factory. The process for this must have been that the inside center section was added with rubber gasket and brass gasket and then spotwelded in the center against the "door". After that the handle was bolted to the door with two silver zinc Phillips screws with star washer. After this the cap was pained on some kind of pin so the "door" got paint on the outside Surface but not the inside of the cap.

Tomorrow I will pick up the NOS chromed one. The process on that one must have been that the inside center section and the rubber and brass gasket was spotwelded to the "door" after the "door" was chromed. The handle must have been chromed separately too.

Tomorrow I will leave all the parts for the interior that needs to be painted.

I will go with a painted one even if I think that a chromed one should look more fancy!